4 | Installation Guide
Server Software Installation
Before you begin, make sure you’ve:
•
Connected the printer to the server
•
Installed the EPSON printer driver (see your EPSON printer
documentation for instructions)
•
Installed the IEEE-1394 driver if you’re using the EPSON Stylus
Pro 10000 (the driver is on the CD-ROM that came with your printer; for
installation instructions, see the Product Support Bulletin at
http://support.epson.com)
•
Closed all open programs and turned off any virus protection programs.
Install the following software on the server:
•
Fiery Spark Server software (see below)
•
Command WorkStation (page 5)
Installing the Fiery Spark Server Software
Follow these steps:
1. Insert the Fiery Spark System Software CD-ROM in your CD-ROM or
DVD drive.
2. Double-click
My Computer
, then double-click the
CD-ROM
icon.
3. Double-click the
Setup
icon in Fiery folder, then click
Next
.
4. Follow the on-screen instructions.
Note
Use a short server name (8 characters or less). Otherwise, you won’t
be able to see the server name and print queue in the Chooser on
Macintosh clients.
Do not install the hardware key until after all the software is installed.
To Next Page
Loading...
