Maintenance 145
User’s Guide
Cleaning inside of the printer
A
Make sure the printer is turned off and all
the lights are off, and then unplug the
power cord from the electrical outlet.
B
Leave the printer for a minute.
C
Open the front cover and use a soft, clean
cloth to carefully clean away any dust or
dirt inside the printer.
Wipe the gray part by following the
directions of the arrows. If there is a serious
problem of dirt on the inside of the printer,
clean it using a soft, clean cloth dampened
with a mild detergent. Then, wipe the
inside of the printer dry with a dry, soft
cloth.
Gray part: Cleaning area
Light magenta part: Do not touch
D
If the back of a print is soiled, wipe the gray
part carefully.
E
If some powdery paper dust is accumulated
on the platen, use something like a
toothpick to remove it.
c
Caution:
❏ Do not touch the light magenta parts (roller
and ink absorption) in the illustration
above; otherwise, prints may be soiled.
❏ Do not touch the ink tubes located inside
the printer.
❏ Be careful not to touch the cables around
the print head; otherwise, the printer may
be damaged.
See “Replacing the Cutter” on page
128.
To Next Page
Loading...
