Paper Handling 39
User’s Guide
D
Make sure that the Paper Check light is on,
and then set the paper lever to the released
position. LEVER RELEASED. LOAD PAPER
appears on the LCD panel.
The paper lever may be locked if REMAINING
PPR SETUP is set to ON: AT ROLL EXCHANGE.
In this case, press and hold the button
for 3 seconds to print the barcode, so you
can release the paper lever.
E
Open the front cover.
F
Load the sheet into the paper insertion slot
so that the bottom edge of the paper rests
behind the open front cover.
Make sure that the right and bottom edges
of the sheet are straight and in line with the
vertical line.
c
Caution:
Do not set the paper lever to the released
position while the Power light or Pause
light is flashing; otherwise, damage may
occur.
c
Caution:
Be careful not to touch the cables around
the print head; otherwise, the printer may
be damaged.
Note:
Load the sheet vertically, like most magazines.
To Next Page
Loading...
