Paper Handling 44
User’s Guide
Removing paper after take-up
After paper take-up, follow the steps below to
remove the take-up reel core.
A
Cut the roll paper.
❏ Press the button to select Roll Auto
Cut On .
❏ Press the button for 3 seconds to cut
the roll paper automatically.
If the roll paper cannot be cut with the
built-in cutter, use a scissors or cutter sold
at a store.
B
Turn the lever to unlock the movable unit,
and then slide it to the left so that the flange
knob clears the end of the take-up reel core.
While doing this, support the take-up reel
core with one hand to keep it from falling.
C
Remove the take-up reel core from the
flange knob on the movable unit and the
drive unit.
Using the core from a used paper
roll as a take-up reel core
You can use a used paper roll as the take-up reel
core.
When you use the 2-inch take-up reel core, you
need to reverse the flanges on the drive unit and
movable unit first.
A
Remove the flange by pinching the knob.
w
Warning:
The paper roll is heavy so have two people
hold it by both ends of the paper roll.
Note:
If the paper roll core is deformed or damaged, it
cannot be used as a take-up reel core.
Note:
Diameters of the knobs on the flange are shown below.
76.2mm (3
"
) 50.8mm (2")
To Next Page
Loading...
