14 Setting Up Your System for Network Printing
Windows XP
For Windows XP, use the following procedure to install the necessary
components.
Note:
The Windows XP CD may be required during the installation.
1. Click Start, select Control Panel, and then select Network Connections.
2. Under LAN or High-Speed Internet, right-click the Local Area
Connection icon and choose Properties.
3. Check if the following network components are in the list. If they are
already installed, go to “Connecting the Network Interface to the Network”
on page 16.
The following table lists the network components required for configuring
the network interface with EpsonNet Config.
EpsonNet Config’s setting screens Necessary components
TCP/IP, SNMP (IP trap) Internet Protocol (TCP/IP)
To Next Page
Loading...
