Setting Up Your System for Network Printing 17
Configuring the Network Interface
After connecting the printer to the network, you need to configure the network
interface for use on a TCP/IP network. The following items are used to make
network settings on the printer’s control panel (available only when
NEWORK SETUP is set to ENABLE):
Follow these steps to set the IP address, subnet mask, and default gateway
from the control panel:
1. Make sure that the printer is turned on, and the LCD displays READY.
2. Press the Menu r button on the printer to enter the printer’s menu system.
3. Press d to highlight NETWORK SETUP, then press r.
4. Press r, then d to highlight ENABLE.
5. Press . An asterisk ( ) appears next to ENABLE to show that it’s selected.
6. Press l to go back, then press d to highlight IP ADDRESS SETTING.
Item Parameter
NETWORK SETUP DISABLE, ENABLE
IP ADDRESS SETTING AUTO, PANEL, PING
IP,SM,DG SETTING IP ADDRESS
000.000.000.000 to 255.255.255.255
(default setting is 192.168.192.168)
SUBNET MASK
000.000.000.000 to 255.255.255.255
(default setting is 255.255.255.000)
DEFAULT GATEWAY
000.000.000.000 to 255.255.255.255
(default setting is 255.255.255.255)
APPLE TALK ON, OFF
MS NETWORK ON, OFF
BONJOUR ON, OFF
INIT NETWORK SETTING EXECUTE
*
To Next Page
Loading...
