E
Attach the chip unit supplied with the new ink
pack to the slider.
Check to confirm that the color of the label on the
slider matches the color of the label on the chip
unit when installing.
F
Hold the slider level horizontally and insert it.
Close the side cover.
c
Important:
Do not push the slider in with too much force.
Failure to observe this precaution could
damage the printer.
G
Shake the new ink pack as shown in the
illustration horizontally for approximately 5 cm
left and right for 5 seconds approximately 15
times.
H
Open the slider ink inlet cover.
I
Remove the ink inlet cap from the ink tank.
SC-F6000 Series User’s Guide
Maintenance
50
To Next Page
Loading...
