Loading Roll Paper into the Secondary Roll Unit | 35
8.
Push the secondary roll unit back into the printer.
9. Check the message on the control panel.
• If the paper type was automatically detected, the printer displays Ready on the LCD screen. The
printer is ready to print.
• If the paper type was not detected, the printer displays the Paper Type and Roll Paper
Remaining
settings for the paper currently selected. Follow the instructions on the control panel
to change or confirm the current settings. Press
OK when finished.
T-Series_Setup_Guide_S.book Page 35 Tuesday, September 16, 2014 2:53 PM
To Next Page
Loading...
