Epson TM-H6000 User Manual

TM-H6000 Users Manual 9
English
1. Wait until the
SLIP
light blinks. Then insert the check
face up
with the right side of the check against the right side of the
paper guide as far as it will go. Be sure that the MICR
characters are on the right.
2. The printer will detect the check and start drawing it in. When
the printer starts drawing it in, let go of the check immediately.
When the printer ejects the check and the
SLIP
light starts
blinking again; remove the check by pulling it straight up; do
not pull it at an angle.
Cleaning the MICR Mechanism
Approximately every 12 months clean the MICR head with a
moistened cleaning sheet.
Use the following or an equivalent commercially available cleaning
sheet:
PRESAT brand (KIC) CHECK READER CLEANING CARD.
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1. Load a paper roll in the printer; turn off the power; then open
the paper roll cover and turn the power back on while holding
down the
RELEASE
button.
MICR
characters
on this side
face up

Epson TM-H6000 Specifications

General

Brand	Epson
Model	TM-H6000
Category	Printer
Language	English