Specifications
*1: 58 mm width paper (57.5 ± 0.5 mm) is also available. For
information on how to change paper width, see Technical
Reference Guide.
*2: 500 mA at maximum for one port. 800 mA at maximum for
total of the two ports.
*3: Available when the PHP function is enabled. For information
on how to setup PHP environment, see TM-i Series PHP Setup
Manual. Be sure to use a micro SD card with the wear
leveling function.
*4: Be sure to use a safety-standards-applied power source that
meets the following specifications.
Rated output
M267A: 24 V/2.0 to 10.0 A
M267D: 24 V/1.5 to 10.0 A
Maximum output
240 VA or less
*5: The current varies depending on the model number. Use the
label on the product to identify the model number and
check the current for your printer.
*6: Reference data: In case of using the Epson power supply,
PS-180 (Model: M159B)
*7: Based on Epson operating conditions.
Item Specification
Printing method Thermal line printing
Roll paper dimensions Paper width*
1
79.5 mm ± 0.5 mm {3.13" ± 0.02"}
Diameter 83 mm {3.27"} maximum
Inside diameter of core 12 mm {0.47"}
Outside diameter of
core
18 mm {0.71"}
Thermal paper type NTP080-80
Interface Ethernet × 1
10BASE-T/100BASE-TX
Serial × 1
D-sub 9 pin male
USB (host) × 2
USB 2.0, Type A
5 V, 500 mA*
2
USB (device) × 1
USB 2.0 High speed, Type B
micro SD card*
3
× 1
Drawer kick-out × 1
Power supply*
4
DC +24 V ± 7%
Current consumption
(at 24 V)*
5
M267A
1.8 A
M267D
1.5 A
AC power consumption*
6
Operating*
7
230 V/50 Hz: 29.4 W
115 V/60 Hz: 29.5 W
Standby 230 V/50 Hz: 2.9 W
115 V/60 Hz: 2.8 W
Temperature Operating 5 to 45°C {41 to 113°F}
Storage –10 to 50°C {14 to 122°F}
Humidity Operating 10 to 90 %RH
Storage 10 to 90 %RH
Overall dimensions W × D × H: 140 mm × 199 mm × 146 mm {5.51"× 7.83" × 5.75"}
Mass (excluding paper and AC adapter) Approx. 1.6 kg {3.55 lb}
To Next Page
Loading...
