TM-T70-i User’s Manual 7
English
Initializing the Network Setting
To reset the network settings to the default values, press the push button at the
interface part (shown in the following illustration) for more than 10 seconds.
When you release the button, the initialization will be started.
Troubleshooting
No lights on the control panel
Check whether the printer is correctly connected to a power source. (See
“Connecting to a Power Source” on page 4.)
ERROR LED on (not flashing) with no printing
❏ Check whether the roll paper cover is closed. If it is open, close it.
❏ If PAPER OUT LED is on, check whether the roll paper is correctly installed
and any roll paper remains.
ERROR LED flashing with no printing (and no paper jam)
Printing stops if the thermal head overheats and resumes automatically when it
cools.
For other cases, turn the printer off, and after 10 seconds, back on.
No connection to external devices
When the status LED (shown in the illustration on page -7) is lit in green
❏ Check whether the interface cable or the wireless LAN cable set (optional product)
is connected correctly. (See “Connecting to External Devices” on page 4.)
❏ Print the status sheet to check whether the network settings are correct. (See
“Confirming the Network Settings” on page 6.)
When the status LED (shown in the illustration on page -7) is off / lit in orange
When the status LED is off after turning on the printer or remains lit in orange
even if 30 seconds have passed after turning on the printer, the interface board
needs repairing.
Paper is jammed
CAUTION:
Do not touch the thermal head because it can be very hot after printing.
1. Turn the printer off and press the cover open lever.
2. Remove jammed paper, reinstall the roll, and close the printer cover.
Status LED
Orange: Booting
Green: Operating normally
Push button
To Next Page
Loading...
Need help?
General
Weight and Dimensions
