8
2. Attach 2 rubber feet on the printer case,
and attach 2 rubber feet on the hanging
bracket.
Hanging the printer on a wall
Follow the steps below to hang the printer on the wall.
!CAUTION:
❏
To fix the printer securely, install the wall hanging bracket on a wall made of
wood, concrete, or metal. The thickness of the wall should be 10 mm {0.4"} or
more.
❏
Be sure to use metallic screws.
❏
The screws on the wall side must have a pull-out strength of 150 N (15.3 kgf) or
more.
1. Install 2 screws (screw diameter: 4 mm {0.16"}, head diameter: 7 to 9 mm
{0.28" to 0.35"} in the wall at an interval of 80 mm {3.15"}. Make sure the
length of the screw’s body in the wall is 10 mm {0.39"} or more, and the
length outside the wall is 3 to 4 mm {0.12" to 0.16"}.
80 mm
3 ~ 4 mm
7 ~ 9 mm
4 mm
10 mm or more
To Next Page
Loading...
Need help?
General