Reference Information 4-1
Chapter 4
Reference Information
Printing Specifications
Printing method: Thermal line printing
Dot density: 180 dpi
×
180 dpi [the number of dots per
25.4 mm (1”)]
Printing direction: Unidirectional with friction feed
Printing width: 72 mm (2.83”), 512 dot positions
Characters per line
(default):
42 (Font A)
56 (Font B)
Character spacing
(default):
0.28 mm (.01”) (2 dots) (Font A)
0.28 mm (.01”) (2 dots) (Font B)
Programmable by control command.
Printing speed -
High speed mode:
28.4 lines/second maximum
(1/6” feed, at 24V, 20° C,
density level 2)
Approximately 120 mm/second
maximum (approximately 4.72”/second
maximum)
Speed is adjusted deepening on the
applied voltage to the printer and head
temperature conditions automatically.
Printing speed -
Low power
comsumption mode:
Approximately 16.5 lines/second (1/6”
feed)
Approximately 70 mm/second
(approximately 2.76”/second)
Printing speed -
when a ladder bar
code is printed:
Approximately 42 mm/ second
(approximately 1.7’’/ second)
To Next Page
Loading...
