Version 3.00 Feb. 2019
APPLICATION DEVELOPMENT GUIDE
POSPrinter (TM-T88V)
6
Make other settings in accordance with the settings described above.
When using with the power saving mode, set DIP-SW2-3 and DIP-SW2-4 to ON.
- TM-T88V with UB-B03
DIP-SW1 DIP-SW2
No. Setting No. Setting
1 OFF Fixed at OFF 1 OFF Settable
2 OFF Fixed at OFF 2 OFF Fixed at OFF
3 OFF Fixed at OFF 3 OFF Settable
4 OFF Fixed at OFF 4 OFF Settable
5 OFF Fixed at OFF 5 OFF Fixed at OFF
6 OFF Fixed at OFF 6 OFF Fixed at OFF
7 ON Fixed at ON 7 OFF Fixed at OFF
8 ON Fixed at ON 8 OFF Fixed at OFF
Set DIP-SW2-3 and DIP-SW2-4(Specification of the print density) to match the
environment of use.
Make other settings in accordance with the settings described above.
When using with the power saving mode, set DIP-SW2-3 and DIP-SW2-4 to ON.
2.3 Port Information
1) Port information w
hen serial port is used
The port information that can be set with the SetupPOS utility is as follows.
Item Setting range
Baud rate [bps] 2400, 4800, 9600, 19200, 38400,
57600,
115200
Bit length [bit] 8
Parity NONE, ODD, EVEN
Stop bit [bit] 1
Handshake DTR/DSR
The default settings are as shown in the following table.
Item Setting range
To Next Page
Loading...
