10
Registering and deleting projectors for monitoring
To end the registration operation, click the in the
top-right corner of the window or click [Cancel].
The icon(s) of the projector(s) you registered will be displayed
in "Grouping view" or "Detail list view".
Refer to "Monitoring window layout" for details on using the
"Grouping view" and "Detail list view".
sp.17
Setting the range of addresses to do an automatic
search and registration
PROCEDURE
f Procedures for automatic search
Right-click in "Grouping view" and select "New" -
"Projector (automatic search)".
The "Create new projector (automatic registration)" window
will be displayed.
• If "Detail list view" is displayed, select "New" - "Projector
(automatic search)" from the "Edit" menu.
Select the "Specify an address range and search"
check box and then enter the starting address and
ending address in the range.
Click [Search].
Automatic searching will be carried out, and the names of the
projectors that have been detected will be displayed.
5
TIP
Projectors that are using a serial
⇔
TCP/IP conversion adapter
cannot be detected.
1
2
3
To Next Page
Loading...
