8 Select OK on the LCD screen to start charging the ink.
Ink charging takes approximately 7 minutes. A message
appears when ink charging is complete.
Caution: Don’t turn off the printer, raise the printer cover, or
open the ink pack tray cover while the printer is charging or you’ll
waste ink.
4
Load paper
For instructions on loading envelopes, legal-size paper, or
using the rear paper feed slot, see the online User’s Guide.
1 Make sure the product is done charging the ink, then pull
out the paper cassette.
2 Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
3 Insert paper with the glossy or printable side down.
Standard paper:
Thick paper:
Note: Make sure the paper is under the arrow mark for your
paper type and loaded against the front edge of the cassette.
4 Slide the edge guides against the paper, but not too
tightly.
3 Remove and discard the protective piece from the ink
pack tray.
4 Shake the ink pack 10 times, then remove it from the
packaging.
Note: Do not touch the green chip on the ink pack.
5 Move the handle forward, place the ink pack into the ink
pack tray until it clicks, then move the handle back to its
original position.
Note: Make sure the ink pack is fully
inserted and level with the top of the
ink pack tray.
6 Insert the ink pack tray into the printer.
7 Close the ink pack tray cover and lock it.
To Next Page
Loading...
Need help?
General
