Notices
37
■
When connecting the product to a computer or other device with a cable, ensure the correct
orientation of the connectors. Each connector has only one correct orientation. Inserting a
connector in the wrong orientation may damage both devices connected by the cable.
■
Do not touch the flat white cable inside the product.
■
Do not move the print head by hand; this may damage the product.
■
Do not spill liquid on the product. Do not use the product near water. Do not use with wet
hands.
■
Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■
Do not press too hard on the scanner glass when placing originals.
■
Do not open the scanner section while the product is copying, printing, scanning, or
performing any other functions.
■
Be careful not to trap your fingers when closing the document cover or scanner.
■
Adjust only those controls that are covered by the operating instructions. Except as specifically
explained in your documentation, do not attempt to disassemble or service any part of the
product yourself.
■
Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance.
■
If damage occurs to the plug, replace the cord set or consult a qualified electrician. If there are
fuses in the plug, make sure you replace them with fuses of the correct size and rating.
■
When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridges.
■
Do not use this product inside medical facilities or near medical equipment. Radio waves from
the product may adversely affect the operation of medical equipment.
■
Keep this product at least 9 inches (22 cm) away from cardiac pacemakers. Radio waves from
this product may adversely affect their operation.
■
Do not use this product near automatically controlled devices such as automatic doors or fire
alarms. Radio waves from this product may adversely affect these devices.
LCD Screen Safety
■
Use only a dry, soft cloth to clean the LCD screen. Do not use liquid or chemical cleansers.
■
If the LCD screen is damaged, contact Epson. If the liquid crystal solution gets on your hands,
wash them thoroughly with soap and water. If the liquid crystal solution gets into your eyes,
flush them immediately with water. If discomfort or vision problems remain after a thorough
flushing, see a doctor immediately.
To Next Page
Loading...
Need help?
General
