Hidden Pages for QX Advanced Configuration
Please Note: This option should not be disabled so that the extension can use all the
patterns in the call routing table.
• Use extension settings in forwarding: Indicates whether CallerIDs of SIP calls received on
the selected extension and forwarded to another SIP destination will be modified to contain
the SIP username of the extension that has forwarded the call. If enabled, the callerIDs of
forwarded SIP calls will contain the call originator’s display name and the SIP URL of the
extension that has forwarded the call. If disabled, the originator’s callerID will be sent to the
forwarded destination without any modification.
• Use alternative call queuing mode: If this checkbox is enabled, the call queue message will
be played simultaneously to all callers in the queue. If disabled, the call queue message will
be played to callers at regular intervals.
Please Note: Do not enable this checkbox, it will break incoming calls’ handling of the
extension.
• Redirect the call to VoiceMail in case of '603 Decline' message received from IP Phone:
When the checkbox is enabled, and IP phone replies ‘603 Decline’ for incoming call (user
presses ‘Reject’ button), the call is being redirected to the Voice Mail of that extension. If the
checkbox is disabled, then the call is being rejected in that scenario. Note: not all IP phones
send ‘603 Decline’ upon pressing of ‘Reject’ – this is implementation specific feature.
• Use original caller Id as call source in Call Routing in case of Transfer/Forwarding: When
the checkbox is enabled, the CM uses original caller’s Id for passing to the Call Routing upon
resolving of call destination (call source filtering works on original caller Id). If the checkbox is
disabled (default), in such scenarios caller Id of transferor/forwarder extension is being used.
This feature was added for some very specific setups, when filtering in the CR should be
done based on caller’s Id.
• Fax message size (kb): Size of system RAM to be allocated for temporary storage of an
incoming fax. Once the fax receipt is complete, it will be stored in the system memory
assigned to the extension as a tiff file. If an incoming fax requires larger storage space, the
system will reject part of the fax that does not fit into the specified space.
To edit any of the advanced settings using the Extensions Management page, click on the link
associated with the corresponding extension or attendant.
Revision 1.0 10 20-Feb-15
To Next Page
Loading...
Need help?
General