Why Equalizer Systems Lifting Systems jacks are jerky when retracting?
Jerky retraction of jacks is often due to air in the hydraulic system, which requires purging. It could also be caused by a low fluid level, so check the fluid level and add fluid as needed.
What to do if the hydraulic pump in my Equalizer Systems Auto Level Automobile Accessories is inoperative?
If the hydraulic pump on your Equalizer Systems Automobile Accessories is inoperative, the following could be the cause: * **Low battery voltage:** Charge the chassis and/or coach batteries. * **Blown fuse or breaker:** Replace the fuse or reset the breaker in the fuse panel. * **Faulty electrical connection:** Trace and repair any faulty electrical connections. * **Defective pump motor or solenoid:** Replace the pump motor or solenoid.
Why Equalizer Systems Auto Level Automobile Accessories jacks will extend but will not retract?
If the jacks on your Equalizer Systems Automobile Accessories will extend but not retract, here are some possible causes: * **Low battery voltage:** Charge the chassis and/or coach batteries. * **Incorrect hose connection:** Check and repair the hose connection at the pump or jack. * **Faulty wire or valve:** Check and repair DV1, looking for faulty wires or valves.
Why are the jacks jerky when retracting on my Equalizer Systems Auto Level Automobile Accessories?
If the jacks on your Equalizer Systems Automobile Accessories retract jerkily, it might be due to: * **Air in the system:** Purge the air from the hydraulic system. * **Low fluid level:** Check the fluid level and add fluid as necessary.
What to do if Equalizer Systems Auto Level jacks retract but won't extend?
If the jacks on your Equalizer Systems Automobile Accessories will retract but not extend, consider the following: * **Low Battery Voltage:** Charge the chassis and/or coach batteries. * **Park Brake:** Ensure the park brake is set. * **Birotational Pump:** Replace the motor and/or solenoid if you have a birotational pump with a bad motor or solenoid. * **Anti-Twist Software:** Lower the opposite side of the coach and/or reset Null and Level Coach if the Anti-Twist Software Protocol has been initiated. * **Ignition Switch:** Check and change the ignition switch position as needed. * **Faulty electrical connection:** Trace and repair faulty electrical connection.
Why Equalizer Systems Lifting Systems jack LED's on keypad stay on?
If the jack LEDs on the keypad stay on, it could be due to a defective pressure switch or wiring, which requires tracing and repair or replacement. Another potential cause is a defective keypad, controller, or pump harness, which also needs tracing and repair or replacement. Low system pressure caused by a fluid leak or low fluid level could also be the reason; correct the leak or fluid level accordingly.
What causes Equalizer Systems Lifting Systems jacks to bleed down from the leveled or stowed position?
Jacks bleeding down from a leveled or stowed position can be attributed to several factors: * Air in the hydraulic system that requires purging. * An external fluid leak that needs tracing and repair. * A defective valve in the pump that should be cleaned or replaced. * A defective jackleg that requires replacement.
What to do if Equalizer Systems Lifting Systems jacks will not retract from extended position?
If the jacks won't retract from the extended position, it could be due to low battery voltage at the pump, so charge the chassis and/or coach batteries. It may also be caused by low battery voltage or poor ground, so charge the batteries and ensure proper grounding. Check for a damaged/defective harness from the Keypad to Controller or Controller to pump, and trace and repair if necessary. Also, check the fluid level and add fluid if it's low. Finally, a defective pump motor or solenoid might be the cause, requiring replacement.
Why is my Equalizer Systems Lifting Systems keypad not turning on?
The keypad might not be turning on due to several reasons. It could be a blown fuse at the pump harness, which requires a fuse replacement. Alternatively, there might be a faulty ground or power wire that needs tracing and repair. A low battery voltage could also be the culprit, so ensure the chassis and/or coach batteries are charged. In some cases, a defective keypad or controller, or a defective keypad or controller harness might be the reason; these would need to be traced and repaired.
What to do if Equalizer Systems Auto Level Automobile Accessories jacks will not retract from full extension?
If the jacks on your Equalizer Systems Automobile Accessories will not retract from full extension, check the following: * **Defective pump motor or solenoid:** Replace the motor and/or solenoid. * **Low battery voltage or poor ground:** Charge the chassis and/or coach batteries and ensure proper grounding to the keypad. * **Damaged or defective harness:** Trace and repair the harness from the keypad to the pump. * **Low fluid level:** Check the fluid level and add as necessary.
Explains manual operation of auto-level keypad.
Details extending jacks to contact the ground.
Guides on using keypad buttons to level the vehicle.
Procedure for retracting jacks before travel.
Lists possible causes and fixes for keypad power issues.
Identifies issues when keypad is active but jacks don't respond.
Addresses problems with jacks retracting but failing to extend.
Troubleshoots jacks that extend but cannot be retracted.
Covers causes and solutions for the auto-level function failing.
Troubleshooting steps for when auto-leveling process halts unexpectedly.
Identifies and resolves problems with the hydraulic pump.
Solutions for jacks losing height after being set.
Troubleshoots jacks stuck in the extended position.
General| Category | Automobile Accessories |
|---|---|
| Installation | Professional installation recommended |
| Type | Automatic Leveling System |
| Operation | Automatic |
| Compatibility | Various RV and trailer models |
To Next Page
