Equinox Systems Shard - Operating Instructions - Advanced Modes; Master;Slave Synchronization; Show Mode Selection and Behavior; Sound Active Mode Operation

www.prolight.co.uk Shard User Manual
7
Operating instructions
Master/slave mode:
Tosetthemasterunit,pressthe“MENU”buttonandusethe“UP”and“DOWN”buttonsontherear
oftheunittoshowSLNd ontheLEDdisplay.Nowpressthe“ENTER”buttonandusethe“UP”and
“DOWN”buttonstochooseNast.Pressthe“ENTER”buttontoconrmthesetting.
Thenselectyourdesiredprogram.
Tosettheotherunitsinslavemode,pressthe“MENU”buttonandusethe“UP”and“DOWN”buttons
ontherearoftheunittoshowSLNdontheLEDdisplay.Nowpressthe“ENTER”buttonandusethe
“UP”and“DOWN”buttonstochooseeitherSL 1~SL 2.Pressthe“ENTER”buttontoconrmthe
setting.Theunitwillnowruninsequencewiththemasterunit.
Toexitoutofanyoftheaboveoptions,pressthe“MENU”button.
PleaseensurethatallslaveunitsaresettothesameDMXchannelmodeasthemasterunit.
Show mode:
Toaccesstheshowmodes,pressthe“MENU”buttonandusethe“UP”and“DOWN”buttonsontherear
oftheunittoshowShNdontheLEDdisplay.Nowpressthe“ENTER”buttonandusethe“UP”and
“DOWN”buttonstochoosebetweenSh 0~Sh 8.Pressthe“ENTER”buttontoconrmthesetting.
Toexitoutofanyoftheaboveoptions,pressthe“MENU”button.
Pleasenote:Show0isarandomshowmodewhereitrunsthroughalltheotherbuild-inshows.
AllshowsapartfromShow2reacttosound.Show2isaslowmovingcolourchangeshow
whichdoesn’treacttosound.
Sound active:
Toaccessthesoundactivesetting,pressthe“MENU”buttonandusethe“UP”and“DOWN”buttonson
therearoftheunittoshowSoUnontheLEDdisplay.Nowpressthe“ENTER”buttonandusethe“UP”
and“DOWN”buttonstochoosebetweenonorofF.Pressthe“ENTER”buttontoconrmthesetting.
Toexitoutofanyoftheaboveoptions,pressthe“MENU”button.
Sound sensitivity:
Toadjustthesoundsensitivity,pressthe“MENU”buttonandusethe“UP”and“DOWN”buttonsonthe
rearoftheunittoshowSensontheLEDdisplay.Nowpressthe“ENTER”buttonandusethe“UP”
and“DOWN”buttonstochoosebetween0~100.Pressthe“ENTER”buttontoconrmthesetting.
Value: 0 - 100 (0 = low, 100 = high)
Toexitoutofanyoftheaboveoptions,pressthe“MENU”button.