What to do if Equinox Systems VS 1500 Fogger Lighting Equipment remote does not work?
If your Equinox Systems Lighting Equipment remote isn't working, ensure the connector is firmly connected to the unit. You can also try using another controller or checking the fuse. If you're using a wireless remote, make sure to check the batteries.
How to troubleshoot no power on Equinox Systems VS 1500 Fogger?
If your Equinox Systems Lighting Equipment isn't powering on, start by checking the mains power supply. Also, inspect the fuse to ensure it hasn't blown.
What to do if Equinox Systems VS 1500 Fogger Lighting Equipment fog machine is not heating up?
If your Equinox Systems Lighting Equipment fog machine is not heating up, first check the fuse. If the fuse is fine, it could be a faulty part, and you should contact your reseller for further assistance.
What to do if Equinox Systems VS 1500 Fogger has no fog output?
If your Equinox Systems Lighting Equipment isn't producing fog, first check the fluid level. Also, check the remote. If you are using a wireless remote, check the batteries.
What to do if Equinox Systems Lighting Equipment fluid indicator states no fog, but the container is full?
If your Equinox Systems Lighting Equipment fluid indicator shows 'no fog' even when the container is full, it could be a faulty part, so contact your reseller for further instructions. You can also try resetting the fog machine by turning the power off, and then on again.
How to fix low fog output on Equinox Systems VS 1500 Fogger?
To address low fog output in your Equinox Systems Lighting Equipment, try running a cleaning solution through the fog machine.
What to do if Equinox Systems VS 1500 Fogger breaker or fuse keeps blowing?
If the breaker or fuse keeps blowing in your Equinox Systems Lighting Equipment, it may indicate a possible electrical short. Contact your reseller for further assistance.
General safety instructions and precautions for operating the fogger, emphasizing proper handling and maintenance.
Specific warning about the risk of electric shock when using the equipment.
Guidelines for correct operation, maintenance, and professional use to prevent damage and ensure safety.
Details the key features of the VS 1500 Fogger, including heater, smoke output, and controls.
Lists technical data such as power consumption, voltage, fuse, dimensions, and weight.
Identifies and explains the various parts and indicators of the VS 1500 Fogger unit.
Lists the items included in the product packaging, such as the fogger and remotes.
Provides instructions on placing the unit, filling fluid, and general operational steps.
Details requirements for installing the fogger in a safe and effective location, including ventilation and distance.
Highlights critical safety warnings related to fire hazards and electrical safety during operation.
Explains how to use both the wireless and wired remote controls for operating the fogger.
Details how to set up and control the fogger using DMX mode, including address configuration.
Provides instructions for cleaning the fogger and performing routine maintenance to ensure longevity.
Offers solutions for common problems encountered with the fog machine, such as no power or low output.
Explains how to assign a unique start address for DMX control of the fixture.
Provides information on the DMX protocol, linking multiple fixtures, and data cable requirements.
Details DMX connector types, pin configurations, and cable adapter information.
Explains the importance and method of using DMX terminators to prevent signal issues.
Provides guidance on the environmentally responsible disposal of the product as electronic waste.
The Equinox VS 1500 Fogger is a high-performance fog machine designed for professional use in various environments, including nightclubs, stage shows, and theatres. It is capable of outputting high volumes of fog and offers multiple control options, including wired remote, wireless remote, and DMX.
The VS 1500 Fogger generates fog using a 1500W heater, producing approximately 15,000 cubic feet of smoke per minute. It operates with water-based fog fluid, which is stored in a 2.3-litre tank. The unit features a robust design and can be controlled via a hand-held wired remote (3.5m cable length), a wireless remote, or through DMX.
Operation: To operate the unit, place it on a level surface. Always disconnect the unit from the mains supply before filling the fluid tank to prevent spills.
Fluid Replenishment: Power down the unit using the on/off switch on the rear panel and unplug the power cable. Turn the fluid bottle lid counter-clockwise to unscrew and remove the fluid tank from the main housing. Fill the tank with fluid, then place it back in the housing. Replace the lid on the fluid bottle and turn clockwise to tighten. Plug the power cable back into the unit and power it on. It is crucial to use only high-quality, water-based smoke fluid recommended by the manufacturer. Operating the machine without sufficient smoke fluid can damage the pump and cause the heater to overheat. Never fill with hot liquids or substances classified as 'DANGEROUS WORKING MATERIALS' or 'FLAMMABLE FLUIDS'.
Installation: Install the unit in a well-ventilated area, maintaining a minimum distance of 1m around the unit. Insufficient ventilation can lead to condensation of smoke fluid, creating slippery surfaces and potential accidents. The output aperture should not be oriented directly towards the audience's eyes. For optimal effect, a distance of at least 3m between the unit and the audience is recommended. The unit should only be installed on fire-resistant, scratch-resistant, and water-resistant surfaces.
Controls: The unit features an output nozzle, safety eye, fluid tank, fluid pipe, and a carry handle. On the rear panel, there is a power on/off switch, remote input, power input, fuse, wireless remote dipswitches, DMX dipswitches, 3-Pin DMX input, and 3-Pin DMX output.
Fluid Tank Indicators: The fluid tank illuminates 'Red' during the heating process. It illuminates 'Red & Blue' to indicate the unit is 'Ready to fog' but still heating. Once fully ready to fog, it illuminates 'Blue'.
DMX Dipswitches: An LED above the DMX dipswitches illuminates when a DMX signal is detected.
Wireless Remote Control: The wireless remote has an LED indicator that illuminates when any button is pressed (if dim, replace the battery). It features four fog buttons (1 to 4). Pressing and holding a fog button will cause the machine to output fog for the duration the button is held. The remote is a 4-channel device, allowing multiple units to be operated simultaneously. Units can be assigned to separate channels (one per button) or multiple units can be set to the same dipswitch number and assigned to a single button on the remote. Note that 'ON' on the dipswitches is in the down position.
Wired Remote Control: The wired remote includes:
DMX Mode: The VS 1500 Fogger can be controlled via DMX-512 protocol. It uses 1 DMX channel for output volume (5-100%). DMX addresses are set using dipswitches on the unit. The DMX address table provides guidance on setting the dipswitches for specific addresses. DMX cables must be daisy-chained.
Cleaning and Maintenance: Frequent cleaning of the unit is recommended. Ensure the machine has cooled before cleaning. Use a soft, lint-free, moistened cloth to clean the exterior. Remove dust from air vents using an air compressor, vacuum, or soft brush. Avoid using alcohol or solvents. Clean the output nozzle after each use to remove fluid residues and water vapour.
Preventing Clogging: To prevent internal pipe blockages, run a cleaning solution through the unit every 40 hours. The solution should consist of 35% vinegar and 65% distilled water. Fog this solution through the system 10-15 times. To do this, power down the unit, unplug the power cable, and remove the fluid tank. Empty any remaining fog fluid and fill the tank with the vinegar/distilled water solution. Replace the tank, plug in the power cable, and power on the unit. Allow it to heat up and run the machine in a well-ventilated area until the tank is empty of the cleaning solution. DO NOT allow the pump to run dry. After the cleaning cycle, power down the unit, empty any remaining solution, and refill the tank with regular fog fluid. Run the machine briefly to clear any remaining solution from the pump/heater.
Disposal: The recommended fluids are non-hazardous and can be disposed of via the sewage system. The product itself, being Waste Electrical & Electronic Equipment (WEEE), should not be disposed of with household waste. It should be recycled responsibly through designated collection systems to promote sustainable reuse of material resources. Household users should contact their retailer or local government office for recycling information. Business users should consult their supplier regarding disposal terms.
Troubleshooting:
There are no user-serviceable parts inside the unit; all repairs, servicing, and power connection work must be carried out by a qualified technician.
General| Brand | Equinox Systems |
|---|---|
| Model | VS 1500 Fogger |
| Category | Lighting Equipment |
| Language | English |
To Next Page
