Equity 30402 User Manual

Page 3Page 2For more information and support visit: bit.ly/30401_alarm or bit.ly/30402_alarm
3INCH JUMBO LED
ALARM CLOCK
MODEL: 30402
DC: 040924
POWER UP
1. Insert the 120 volt power cord into an outlet.
Optional: Insert 1 “9V” battery (sold separately) for backup.
2. The Time Display will flash 12:00, an indication to set the time.
TIME SETTING
1. Move the TIME/ALARM/RUN Set Switch to the TIME position.
2. Press HOUR button to set your hour. Note: The PM Indicator
will appear when you advance to PM time.
3. Press MINUTE button to set your minutes.
4. When the correct time is shown on the display, move the
TIME/ALARM/RUN Set Switch to the RUN position.
ALARM TIME SETTING & OPERATION
1. Move the TIME/ALARM/RUN Set Switch to the ALARM position.
2. Press HOUR button to set your alarm hour. Note: The PM
Indicator will appear when you advance to PM time.
3. Press MINUTE button to set your alarm minutes.
4. When the correct time is shown on the display, move the
TIME/ALARM/RUN Set Switch to the RUN position.
5. Slide the Alarm HI/LO/OFF Switch to LO position for normal
alarm volume, and to its HI position for a louder alarm volume.
Note: The Alarm Indicator will appear when the alarm is on.
6. To turn o a sounding alarm, move the Alarm HI/LO/OFF Switch
to the OFF position.
SNOOZE
When alarm sounds, press the SNOOZE button to silence alarm for
8 minutes. Snooze function can be repeated many times if desired.
DISPLAY DIMMER
Move the Dimmer Switch to its LO position for normal display
brightness, and to its HI position for a brighter display.
BATTERY BACKUP
• Insert 1 “9V” battery (sold separately) into the Battery
Compartment on the bottom of the clock. This will keep your
time and alarm settings saved until power is restored.
• The LED display will not light up, but the alarm will still sound at
the preset alarm time.
Note: If there is no battery installed and the power is interrupted,
the display will flash 12:00 and the time and/or alarm will need to
be set again.
STAY IN TOUCH
Ask questions, watch set up videos, and provide feedback on our social media
outlets. Follow La Crosse Technology on Youtube, Facebook, Instagram, & X
(Twitter).
POWER REQUIREMENTS & DIMENSIONS
Power: 120V Power Cord
Battery Backup: “9V” battery (sold separately)
Dimensions: 9.00" L x 2.25" W x 4.75" H
22.86 cm L x 5.72 cm W x 12.07 cm H

Equity 30402 Specifications

General

Brand	Equity
Model	30402
Category	Alarm Clock
Language	English

Summary

Power Up and Time Setting

Power Up Instructions

Setting the Time

Use the TIME/ALARM/RUN switch and HOUR/MINUTE buttons to set the current time.

Alarm Time Setting and Operation

Configure the alarm hour and minutes, and select alarm volume (HI/LO).

Battery Backup Functionality

Install a 9V battery for backup to retain settings during power interruptions.

Care, Maintenance, and Safety

Electrical Shock Prevention Warnings

Important warnings about avoiding water, moisture, and proper plug usage.

Service and Internal Components

General Safety Instructions

Service and Damage Handling

California Proposition 65 Warning

Warning about exposure to chemicals known to cause cancer or reproductive harm.

Regulatory and Compliance Information

User Safety and Supervision

FCC Statement and Interference

Equipment tested for FCC compliance; measures to correct radio interference provided.

Modification Warning