10
INSTRUCTIONS MANUAL
6.TROUBLESHOOTING
6.1 Why is the monitor in black screen?
6.3 Why does the camera gets blurry or foggy?
1. Check the external lenses. Clean them by simply wiping off the
dirty.
2. Check if there any loose or faulty connections triggering such
mishaps.
3. There is moisture inside the camera's lenses. The changes between
high and low temperature will cause fogging problems, just wait a
few hours and it will return to normal.
4. If there is still no improvement, maybe the camera has been
subjected to some collision during transportation or use,or it is a
defective product,please contact us and we will help you: sales2@
6.2 Why is the monitor no signal or blue?
1. No signal or blue screen is the camera is not turned on and it
does n't pair with camera.
2. Check if the camera is powered up first.
3. Pair the camera with the monitor up close
(
within 5ft
)
and and wait
until the pair is successful, and the monitor will work.
If there is still no improvement, please contact us to send you an
1. Check if the monitor is powering on and press the power botton to
see if the monitor turn on. If you are sure the monitor has power and
it does not respond to the on/off button, then disconnect it from the
power and recoonecting.
2. Check if the camera is powered. The monitor can only be used
normally when monitor and camera are powered.
3. Check there is 12v going to the monitor. If there is still no
improvment, maybe the monitor has been subjected to some collision
during transportation or use, please contact us and we will help you:
sales2@erapta.com.
extension antenna or replacement.
erapta.com
To Next Page
Loading...