INSTRUCTIONS MANUAL
4
4.2 Installation of the Camera
4.2.1 Take off your rear license plate.
Using a screwdriver, remove each of the screws holding your rear
license plate in place. Then, pull the plate off and set it aside.
NOTE: Make sure you place the screws in a safe place so you
don’t lose them.
4.2.2 Drill a small hole in the license plate mounting area
Drill a small hole in the license plate mounting area so you can run the
cable into the trunk.
Hold your camera up to the area you intend to mount it to figure out
where to make the hole and mark the fixed position and note the spot
where its splitting cord sits.
To Next Page
Loading...
