4 5
OPERATING MANUAL SYMBOLS
Take notice: Failure to heed instruction may result in
injury, or even death
MODULE LABEL SYMBOLS
Warning: Cutting of Fingers or Hand, Blade
Warning: Pinch Point Hand Entanglement
Warning: Cutting of Fingers or Hand, Moving Part
Emergency Stop Button (Terminates power to unit)
Turn Knob Symbol
On/Off Button: I = On / O = Off
Ground Point Symbol
DEFINITIONS AND LABELS
5
SAFETY PRECAUTIONS
IMPORTANT! DO NOT OPERATE MACHINE UNTIL YOU HAVE READ THOROUGHLY, AND
UNDERSTAND COMPLETELY, ALL PRECAUTIONS, INSTRUCTIONS AND INFORMATION ON
THESE PAGES. THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS.
IT SHOULD BE RETAINED WITH THE MACHINE FOR FUTURE REFERENCE.
! Note: Not following the precautions and instructions in this manual will impair the
protection of the operator/user and the equipment.
! Note: Any time the M700F (Feeder Module) is used, the operator/user must ensure that the
material path (both downstream and upstream modules) is free of any obstructions. These
areas may be a hazard and should be managed accordingly.
MECHANICAL
! DO NOT OPERATE UNIT WITHOUT GUARDS IN PLACE OR WITH DAMAGED GUARDS.
! DO NOT DEFEAT OR BYPASS ANY OF THE SAFETY FEATURES.
! DO NOT PLACE FINGERS OR APPENDAGES NEAR MOVING PARTS.
! NEVER ALTER OR MODIFY THE MACHINE IN ANY WAY.
ELECTRICAL
! ALWAYS UNPLUG UNIT FROM POWER SUPPLY PRIOR TO ANY MAINTENANCE.
! DO NOT RUN UNIT ON INCORRECT VOLTAGE SETTING.
! NEVER RUN MACHINE WITH DAMAGED OR WORN POWER CORD.
! NEVER MODIFY THE PLUG PROVIDED. IF IT WILL NOT FIT INTO THE OUTLET, HAVE THE PROPER
OUTLET INSTALLED BY A QUALIFIED ELECTRICIAN.
! NEVER ALTER OR MODIFY THE MACHINE IN ANY WAY.
GROUNDING INSTRUCTIONS
Grounding provides a common return path for electric current to reduce the risk of electric
shock. This machine is supplied with an electric cord with an equipment-grounding
conductor and a grounding plug. The plug must be plugged into a matching outlet that is
properly installed and grounded in accordance with all local codes and ordinances. Improper
connection of the equipment-grounding conductor can result in a risk of electric shock. Check
with a licensed electrician if in doubt as to whether the machine is properly grounded.
SAFETY FIRST – USE BEST PRACTICES
ALWAYS USE SAFETY GLASSES
Everyday eyeglasses only have impact resistant lenses; they are NOT safety glasses.
Use face or dust mask if cutting operation is dusty.
DO NOT MOVE ASSEMBLED UNITS
Always disassemble units prior to moving units. Keeping them connected during moving
may harm interface connector.
REMOVE ADJUSTING KEYS AND WRENCHES
Form a habit of checking to see that keys and adjusting wrenches are removed from the
machine before turning it on.
KEEP WORK AREA CLEAN
Cluttered areas and benches invite accidents. Always leave at least 12” (30.5cm) of space
around all sides, and on top of unit.
To Next Page
Loading...