Erbauer EBP28 - Page 21

21
EBP28
Getting Started . . .
Before you start
NOTE: Risk of machine damage!
Never mix fuel and oil directly in the tank of the machine.
Use an anti-oxidant added quality oil expressly labelled for air-cooled 2 stroke Use an anti-oxidant added quality oil expressly labelled for air-cooled 2 stroke
engine use (JASO FC GRADE OIL or ISO EGC GRADE). Do not use BIA or engine use (JASO FC GRADE OIL or ISO EGC GRADE). Do not use BIA or
TWC (2 stroke water-cooling type) mixed oil. The recommended mixing ratio TWC (2 stroke water-cooling type) mixed oil. The recommended mixing ratio
for petrol:oil is 40:1, which means the mixture consisting of 40 parts petrol for petrol:oil is 40:1, which means the mixture consisting of 40 parts petrol
and 1 part oil.and 1 part oil.
4. Unscrew and remove the fuel tank cap (10). Use the multi-tool (20) to unscrew or
tighten the cap if necessary (Fig. 4).
4
11
10
20
5. Fill the fuel into the fuel tank (11). Leave approximately 5 mm of space between
the top of the fuel and the inside edge of the tank to allow for expansion (Fig. 5).
Do not overll.
5
5 mm
6. Wipe up spilled fuel with a soft cloth. Ret and screw the fuel tank cap (10) rmly
(Fig. 4).