20
EBP28
Getting Started . . .
Filling up fuel and oil
WARNING! This machine is not supplied with petrol-oil mixture in the engine!
Before operating this machine it is essential to ll it with petrol-oil mixture!
This machine is equipped with a 2-stroke engine, the fuel and oil tank are combined
and it is essential to ll a fuel-oil mixture before operating this machine. Observe the
technical specications for suitable fuel and engine oil.
WARNING! Fuel and oil are highly inammable! Fumes will
explode if lit! Ensure that there are no naked ames around the
machine! Do not smoke while lling fuel and oil!
NOTE: To avoid spillage and to lter out debris, use a funnel with lter to ll
the fuel mixing bottle (23) and the fuel tank (11).
1. Place the machine on a stable, level surface with the fuel tank cap (10) facing
upwards. We recommend laying a non-ammable sheet under the machine.
2. Pour a regular-grade unleaded petrol and a quality engine oil for air cooled 2-stroke
engines in the supplied fuel mixing bottle (23) respectively via the 2 openings.
Use the scale markings on different sides for your desired ratio for petrol:oil. For
example, ll petrol to scale marking “10” rst, and then ll 2-stroke oil to scale
marking “10”. This indicates a correct ratio of 40:1 when using the scale 40:1.
=
100 ml + 2.5 ml =
40:1
200 ml + 5 ml =
300 ml + 7.5 ml =
400 ml + 10 ml =
3. Tilt and shake the fuel mixing bottle (23) thoroughly to make the fuel.
Before you start
To Next Page
Loading...