24
AUTOMATIC LED WORK LIGHT (J)
The LED work light (8) will illuminate when the trigger switch is depressed slightly, and
will automatically turn off a short while after the trigger switch is released. This provides
additional light on the surface of the workpiece for operation in lower light situations.
WARNING!
Do not look directly into LED light.
DRILLING
When drilling into a hard smooth surface, use a centre punch to mark the desired hole
location. This will prevent the drill bit from slipping off centre as the hole is started. Hold
the tool rmly and place the tip of the bit at the point to be drilled. Depress the switch
trigger to start the tool. Move the drill bit into the workpiece, applying only enough
pressure to keep the bit rotating. Do not force or apply side pressure to elongate a hole.
WARNING!
Tungsten carbide drill bits should always be used for
concrete and masonry. When drilling in metal, only use HSS drill bits in
good condition. Always use a magnetic bit holder (not included) when using
short screwdriver bits. When screw-driving, apply a small quantity of liquid
soap or similar to the screw threads to ease insertion.
Where possible, secure smaller work pieces to prevent them from moving
during operation.
To Next Page
Loading...
