22
USE
01
INTENDED USE
This product is intended for drilling in wood and similar materials e.g. MDF, plywood etc,
plastic, metal and impact drilling in brick, tile, concrete, as well as for screw driving.
02
OPERATION
ON / OFF SWITCH (D)
Depress the on/off switch (11) to start and release it to stop your drill. The on/ off switch is
tted with a brake function which stops your chuck immediately when you quickly release
the switch. It is also a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
WARNING!
Do not operate for long periods at low speed because
excess heat will be produced internally.
SWITCH LOCK (E1)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility
of accidental starting when not in use. To lock the switch trigger, place the rotation control
(5) in the centre position.
FORWARD/REVERSE ROTATION CONTROL (E2, E3)
WARNING!
Only change the rotational direction when the product
is switched off and has come to a complete stop! Always ensure that
the forward / reverse rotation control is adjusted to the correct position
depending on the intended operation!
Always push the forward / reverse rotation control as far as it will go! Do not
use the product with the control switch in any other intermediate position!
To Next Page
Loading...
