24
ECSP41
Getting Started . . .
Chain lubrication
WARNING! The product is not lled with chain oil. It is essential to ll the
product with chain oil before using it! Never operate the product without chain
oil as this will result in extensive damage to the product! Operating the saw
chain dry or with too little chain oil will decrease cutting efciency, shorten the
product life span and cause rapid wear to the saw chain (3) and guide bar (2)
from overheating! Insufcient chain oil is evident by smoke or bar discoloration!
Adequate lubrication of the saw chain during cutting operations is essential to
minimise friction with the guide bar (2).
1.
Place the product on a stable, level surface with the oil tank cap (16) facing upwards.
We recommend laying a non-ammable sheet under the product.
2. Unscrew and remove the oil tank cap (16) by turning it anti-clockwise (Fig. 10). Use
the multi-tool (24) to unscrew or tighten the cap if necessary.
10
16
24
Before you start
To Next Page
Loading...
