Erbauer EHTP22 - Before You Start; Set Up

15
EHTP22
Getting Started . . .
Before you start
Set up
Removing the cutting device transport guard
CAUTION! Risk of cuts! Cutter blades (9) are very sharp. Wear protective
gloves when handling cutter blades (9).
Remove the cutting device transport guard (23) carefully from the cutting device (8) (Fig. 1).
1
23
8
NOTE: Always attach the cutting device transport guard (23) back onto
the cutting device (8) when the equipment is not in use, and for storage or
transportation.
Adjusting the rear handle
CAUTION! Risk of loss of balance! Only adjust the handle position when
the engine is switched off.
1. Press and hold the rear handle adjustment lever (17), then rotate the rear handle (1)
to the desired position (90°/ 0°/ -90°) (Fig. 2, 3, 4 and 5).
2
1
17