30
EHTP22
In more detail . . .
After use
1.
Stop the engine, disconnect the spark plug connector and let the engine cool down.
2. Check, clean and store the equipment as described below.
WARNING! The cutting device (8) continues to move for some time after
the engine has been switched off. Wait until the cutting device comes to a
complete stop before setting the equipment on the ground.
The golden rules for care
WARNING! Always stop the engine, disconnect the spark plug connector (10)
and let the engine cool down before performing inspection, maintenance and
cleaning work.
DANGER! Proper maintenance is essential for safe and trouble free operation.
Improper maintenance, or failure to address a problem instantly can cause a
malfunction which can result in serious injury or even death.
1. Keep the equipment clean. Remove debris after each use and before storage.
2.
Regular and proper cleaning helps to ensure safe operation and prolongs the life
of the equipment.
3.
Inspect the equipment before each use for worn and damaged parts. Do not operate
it if you nd broken and worn parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the equipment again.
WARNING! Only perform repairs and maintenance work according to these
instructions! All other works must be performed by a qualied person!
Operation / Care and maintenance
To Next Page
Loading...
