in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a
hazard.
trOUBLeShOOtInG
1. If your sander will not operate, check the
power at the mains plug.
2. If the sander does not abrade surface,
checking the sanding paper. If the sanding paper
has been worn, replace the new paper and try
again. The paper must be kept in a dry place,
if it is allowed to become damp, the abrasive
particles will lose their adhesion to the backing
paper and will not abrade.
3. If the sander dose not move smoothly, The
sanding paper may be loose, damaged or
wrinkled. Replace and try again.
4. If a fault can not be rectified return the sander
to an authorised dealer for repair.
To Next Page
Loading...
