Erbauer ERB2504SE - Mitre Cuts Operation; Using the Dust Port; Machine Transportation

ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
ERBAUER 250MM TABLE SAW
10.
Mitre cuts
This sawing operation is the same as
crosscutting
except the mitre gauge is locked
at an angle other than 90°.
1) Set the blade (1) to 0° bevel angle and
tighten the blade bevel lock knob.
2) Set the mitre gauge (3) at the desired mitre
angle and
lock in position by tightening the
mitre gauge locking
handle.
3) Hold the workpiece (2) fi rmly against the
face of the mitre gauge throughout the cutting
operation
(See fi g. 23)
.
11. Using the dust port
Warning
:
●
To prevent fi re hazard, clean and
remove sawdust from under the saw
frequently.
●
To prevent sawdust build up inside the saw
housing, attach a
vacuum hose (1) to the dust
port (2) at the rear of the table saw. DO NOT
operate the saw with the hose in place unless
the vacuum is turned on (
See fi g. 24)
.
Note
:
A 58-37 mm dust port adapter (3) is
provided for your convenience.
12.
Transportation the machine
1)
S
ymbol
for transportation position
(
See fi g. 25).
Warning
:
When transporting the machine use only
transportation devices and do never use
guards for handling or transportation.
Fig
23
3
2
1
Fig
24
Fig
25
1
1
2
3