reason, switch off the power tool and hold the power tool
motionless until the wheel comes to a complete stop. Never
attempt to remove the wheel from the cut while the wheel is
in motion otherwise kickback may occur. Investigate and take
h) Do not restart the cutting operation in the workpiece. Let
the wheel reach full speed and carefully re-enter the cut. The
in the workpiece.
i) Support panels or any oversized workpiece to minimize the
risk of wheel pinching and kickback. Large workpieces tend to
workpiece near the line of cut and near the edge of the workpiece
on both sides of the wheel.
j) Use extra caution when making a “pocket cut” into existing
walls or other blind areas.
ADDITIONAL SAFETY RULES:
1. Always wear a dust mask.
2. Always wear safety glasses or eye shields when using the
WALL CHASER Everyday eyeglasses have only impact-
resistant lenses; they are NOT safety glasses. Following this
3. Always wear hearing protection during extended periods
of operation. Following this rule will reduce the risk of serious
4. Keep your hands away from cutting area. Do not reach under
5. Do not use dull or damaged blades. Bent blades can break
easily, or cause kickback.
6. Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
7. Fully unwind cable drum extensions to avoid potential
overheating.
8. When an extension cable is required you must ensure it has
To Next Page
Loading...
