27
CARE & MAINTENANCE
THE GOLDEN RULES FOR CLEANING
WARNING!
Always switch the product off, disconnect the product
from the power supply and let the product cool down before performing
inspection, maintenance and cleaning work!
• Keep the product clean. Remove debris and dust from it after each use and before storage.
• Regular and proper cleaning will help ensure safe use and prolong the life of the product.
WARNING!
Only perform repairs and maintenance work according
to these instructions! All further works must be performed by a qualied
specialist!
• Inspect the product before each use for worn and damaged parts. Do not operate it if you
nd broken and worn parts.
GENERAL CLEANING
• Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
• In particular clean the air vents after every use with a cloth and brush.
• Remove stubborn dirt with high pressure air (max. 3 bar).
WARNING!
Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be harmful to
its surfaces.
• Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
MAINTENANCE
Before and after each use, check the product and accessories (or attachments) for wear
and damage. If required, exchange them for new ones as described in this instruction
manual. Observe the technical requirements.
POWER CORD
If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
To Next Page
Loading...