25
USE
01
INTENDED USE
The machine is intended for cutting and grinding metal and stone materials without using
water. For cutting, a special safety guard for cutting (accessory) must be used.
WARNING!
Always switch the product off and disconnect it from power
supply before making any adjustments!
02
OPERATION
OPERATING INSTRUCTIONS
• Clamp the workpiece if it does not remain stationary due to its own weight.
• Do not strain the machine so heavily that it comes to a standstill.
• Grinding and cutting wheels become very hot while working, do not touch until
they have cooled.
• Pull the plug from the socket-outlet when not using the machine. With the plug
inserted and mains voltage applied, the power tool still has low power consumption
even when it is switched off. ( E )
STARTING OPERATION ( F )
To start the power tool, push the on/off switch (7) forward.
To lock the on/off switch (7), press the on/off switch (7) down at the front until it engages.
To switch off the power tool, release the on/off switch (7) or, if it is locked, briey push
down the back of the on/off switch (7) and then release it.
1.
Hand grip areas
Always hold your angle grinder rmly with both hands when operating ( G ).
2.
Grinding ( G )
The best grinding results are achieved when setting the machine at an angle of 15°
to 30°. Move the machine back and forth with moderate pressure. In this manner, the
workpiece will not become too hot, does not discolour and no grooves are formed.
To Next Page
Loading...
