Operation
03/2014 1008463-01 Operating instructions – 15/28
5.3 Start
The device is started automatically with an internal or external timer.
NOTE:
Timer instructions see separate manual
(order no. 1008370-..).
5.3.1 Preparation time
WARNING!
Wrong positioning may result in overexposure!
To obtain the recommended exposure schedule position of
a minimum distance of 1/2" (13 mm) measured with a
standard ruler:
– Lie on acrylic surface of lounge and lower canopy.
Canopy will stop at the correct distance from lounge
acrylic surface.
Before the UV lamps turn on, you have a few minutes to prepare yourself.
During the preparation time you can switch on the UV lamps at any time by
pressing the START/STOP button.
– Remove your clothes and all jewelry.
– Remove make-up and other cosmetics.
– Remove glasses. Contact lenses can be worn under the protective gog-
gles.
– Put on the protective goggles.
– Lie down on the bed surface.
– Close the canopy.
– Press the START/STOP button.
Settings on start-up:
UV lamps
Facial tanner
Cooling
5.3.2 Interrupt or end tanning session
The tanning session ends automatically after the preset time has run down.
The internal fan continues to run for approx. three (3) minutes to sufficiently
cool the device.
– To interrupt a tanning session, press button START/STOP anytime dur-
ing a session.
– Press START/STOP again to restart the lamps.
To Next Page
Loading...
Need help?
General
