Advanced Features
Fixed Wireless Terminal: G32 and G36 models 27
To manage Call waiting Function… Dial… You will hear…
Check status *#43#
1 beep if activated
3 beeps if deactivated
Note: If instead of hearing beeps you hear a deep tone, this means
that there has been an error in the activation or deactivation.
Making a Second Call
You can only put one call on hold while you make a second call.
• To hold the active call: press the R
R R
R key on your telephone and
proceed to make the second call.
• To switch between the two calls, press R2
R2R2
R2.
• To finish the active call and return to the held call, press R1
R1R1
R1.
Receiving a Second Call
If the call waiting service is on, you hear a tone in the telephone when you
receive a second call.
• To ignore the waiting call, take no action.
• To continue with the ongoing call and reject the waiting call
(give a User Busy indication tone to the waiting call): press R0.
R0. R0.
R0.
• To end the ongoing call and answer the waiting call: press R1.
R1. R1.
R1.
Note: If you hang up the telephone, you will also end the ongoing
call and the telephone will ring again so that you can answer the
waiting call as a normal call.
• To put the ongoing call on hold and answer the waiting call:
press R2
R2R2
R2. You can switch again between both calls by pressing
R2
R2R2
R2
each time.
Note: If “divert when busy” is on, the waiting call is diverted to the
number you have specified.
Conference Calls
In a conference call, you can have a joint conversation with up to four
other participants.
To create a conference call
• If you are in conversation with participant 1, put it on hold
(press R), and dial participant 2.
To Next Page
Loading...