RBS 2308 and RBS 2309 User’s Guide
1. Remove the cover. Remove the
existing flash card by pulling up
the adjacent black plastic lever
and then pushing it down to eject
the card.
P010366A
2.
Insert the new flash card, push
it in, and reset the release lever
(ensuring that the card is in
position).
P010157A
Flash
Card
3. Put back the cover.
5.4.6 Installing the IXU
This section describes how to install the Interface and Switching Unit (IXU)
on the MBU.
Note: This section is valid only for the master RBS. IXU is not used in
extension RBSs.
56
EN/LZT 720 0027 Uen R8A 2006-06-27
To Next Page
Loading...