- 10 -
Digit 10:
28 ODKSIF 0 = DK SIF INTERNAL
1 = DK SIF EXTERNAL
29/30 CHANNEL NUMBER 0CHAN2 0CHAN1
100 0 0
200 0 1
254 1 0
NU: NOT USED RES: RESERVED
ii. Data Setting
The data setting item B~D is the initialization data preset in the EEPROM before adjustments described in the
following paragraph, in case of changing the EEPROM, please set the data to initialization data listed below,
before adjustment, how to set the data by hand is described in “method to enter into SERVICE MENU and
ADJUST MENU”.
Parameter Value(DEC) Remark Parameter Value(DEC) Remark
SUB BRI 63 HOR.POS60 13
CUTOFF R 63 VER.POS60 0
CUTOFF G 63 VER.H60 81
CUTOFF B 63 VER.LIN60 40 Remark1
DRIVE R 63 VER.S C60 20 Remark1
DRIVE B 63 SUBTINT 16
AFT ADJ 55 AV S TINT 16
RFAGCDP 45 C-Y 1 Remark2
SECAM BL 0 HOR.VCO 52
RGB LIMIT 0 VIF.VCO 26
HOR.POS 13 ISUD5 1 Remark3
VER.POS 0 ISUD4 1
VER.HEI 84 ISUD3 1
VER.LIN 40 Remark1 CONTR 32 0
VER.S CUR 20 Remark1 RI CUTOF 1
Remark1: For different CRT, the following data are recommended to changed for better performance
before alignment.
These data setting are listed as following:
CRT CRT Type No. Value
VER.LIN VER.SCUR VER.LIN60 VER.SC60
21” 102-321001-03 54SX503Y22-DC01 N2 38 20 36 20
IRICO
Remark2: C-Y: 0 For MFxx models (use NN5198K).
C-Y: 1 For other models (use NN5199K/NN5099K).
Remark3: ISUD5 must set to “0” after. Please checked ISUD5 after Read 5198.
iii. Intelligent picture control (I.P.C) DATA SETTING
Control Value
Natural Sharp Cinema Personal
Brightness 16 24 12 16
Contrast 24 32 16 24
Colour 16 20 16 16
Sharpness 16 24 16 16
Tint 16 16 16 16
To Next Page
Loading...