Erreka NAOS - User Manual

11
NAOS
Quick installation and programming guide English
WARNING
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. You can download the installation manual in the
"Downloads" section of the Erreka website:
http://www.erreka-automation.com
I260B
Elements of the complete installation
Electrical wiring
A: Main power supply
B: Closing photocells
C: Pushbutton/wall key
D: LUMI flashing light
Assembly levels
Level H: the track should remain 10
cm above the highest point of the
door (see detail
H
).
Total length (operator + guide) and
effective travel:
– track ref. ANA01; pos
J
:
3502 mm / 2741 mm
– track ref. ANA01; pos
K
:
3452mm / 2,691mm
– track ref. ANA02; pos
J
:
4602mm / 3,841mm
– track ref. ANA02; pos
K
:
4552mm / 3,791mm
 Disconnect the power supply before connecting
or disconnecting any component.
A.T., S and STOP devices must be voltage-free in
order to prevent any damage to the control board.
A.T. Wall key or button
S Closing safety device (closing photocell)
AUX Power supply for peripherals (24 Vdc)
STOP Emergency shutdown
LAMP Warning light (24 Vdc)
Battery connection using sp+ and sp- wire
connectors (inside the frame). Charger CHG01 is
required (included in kit ADO01 with 12V 1.2Ah
batteries).
P260M
Electrical connections
Unlocking
Manual operation unlocking: pull the knob or cable
(1) until the release lever (2) is vertical.
Motorised operation locking: place the lever in
horizontal position (3). Locking will take place when the
operator starts up.
D260C
3
MSP-029/01

Summary

Elements of the Complete Installation

Assembly Levels

Specifies track height and total/effective travel based on track type and position.

Electrical Wiring Components

Lists components for electrical connections: main power, photocells, pushbutton, and flashing light.

Electrical Connections and Operation

Manual Operation Unlocking

Procedure to pull the knob or cable to unlock the operator manually.

Motorised Operation Locking

Method to place the lever horizontally for locking when the operator starts.

Physical Assembly Steps

Securing Track and Operator

Attaching the track to the operator, allowing for 0° or 180° positioning.

Positioning Supports and Anchor

Placing overhead strips, front support, and door anchor, considering assembly level.

Mounting and Chain Tensioning

Mounting the track/operator assembly and adjusting chain tension.

Installation and Programming

Installing Central Support and Stopper

Installing the central support and the opening stopper for correct travel programming.

Radio Code Programming

Procedure for programming transmitter codes, including fixed, roller, or personalized types.

Parameter Programming - Door Positions

Setting the door's open position by stopping the carriage against the opening stopper.

Parameter Configuration

Parameter Programming - Closed Position

Setting the door's closed position by stopping the carriage against the closing stopper.

Force and Sensitivity Adjustments

Learning opening/closing forces and adjusting opening/closing sensitivities.

Radio Type and Closing Mode Setup

Selecting radio transmitter type and semi-auto/auto closing mode with standby time.

Advanced Parameter Settings and Display

Speed and Slowdown Adjustments

Configuring opening/closing speeds and slowdown distance during closing.

Opening Mode and Operation Counter

Setting opening mode and viewing the operation counter.

Display Indications During Use

Explains various status codes and their meanings shown on the display during operation.

Erreka NAOS Specifications

General

Brand	Erreka
Model	NAOS
Category	Garage Door Opener
Language	English