NAOS

Quick installation and programming guide English

WARNING

This quick guide is a summary of the complete installation manual. The manual contains safety warnings and

other explanations which must be taken into account. You can download the installation manual in the

"Downloads" section of the Erreka website:

http://www.erreka-automation.com

I260B

Elements of the complete installation

Electrical wiring

A: Main power supply

B: Closing photocells

C: Pushbutton/wall key

D: LUMI flashing light

Assembly levels

Level H: the track should remain 10

cm above the highest point of the

door (see detail

Total length (operator + guide) and

effective travel:

– track ref. ANA01; pos

3502 mm / 2741 mm

– track ref. ANA01; pos

3452mm / 2,691mm

– track ref. ANA02; pos

4602mm / 3,841mm

– track ref. ANA02; pos

4552mm / 3,791mm

 Disconnect the power supply before connecting

or disconnecting any component.

A.T., S and STOP devices must be voltage-free in

order to prevent any damage to the control board.

A.T. Wall key or button

S Closing safety device (closing photocell)

AUX Power supply for peripherals (24 Vdc)

STOP Emergency shutdown

LAMP Warning light (24 Vdc)

Battery connection using sp+ and sp- wire

connectors (inside the frame). Charger CHG01 is

required (included in kit ADO01 with 12V 1.2Ah

batteries).

P260M

Electrical connections

Unlocking

Manual operation unlocking: pull the knob or cable

(1) until the release lever (2) is vertical.

Motorised operation locking: place the lever in

horizontal position (3). Locking will take place when the

operator starts up.

D260C

MSP-029/01

Erreka NAOS - Installation Guide Manual

Table of Contents

Other manuals for Erreka NAOS

Related product manuals