Erreka VIVO-M201 - User Manual

5
VIVO-M201(M)
Quick installation and programming guide English
IMPORTANT
NOTE
This quick guide summarises the full installation manual. The full manual contains safety warnings and other
explanations that must be taken into account. You can download the latest version of this guide and the
installation manual in the "Downloads" section of the Erreka website:
http://www.erreka-automation.com
The options and functions described in this guide are applicable from the firmware version indicated on the
circuit. As part of a process of continuous improvement, the firmware is subject to the incorporation of new
functionalities or their extension, and consequently to the generation of new versions not necessarily
compatible with the previous ones. Therefore, if your firmware version is lower than the one indicated in
this guide, some options and functions may not be available or may be different.
ELECTRICAL CABLING:
Element Nº wires x section Maximum length
A: Main power supply 3x1.5mm
2
30m
B: Flashing light 2x0.5mm
2
20m
C: Photocells (Tx / Rx) 2x0.5mm
2
/ 4x0.5mm
2
30m
D: Key switch 2x0.5mm
2
25m
E: Operator 4x0.75mm
2
20m
F: Antenna Coaxial cable 50k (RG-58/U) 5m
Elements of the complete installation
MSA-098/04 firmware V2.05 (VIVO-M201) / V2.06 (VIVO-M201M) or later

Summary

Important Safety and Usage Notes

Important Note

Summarises the full installation manual, containing safety warnings and explanations. Download latest versions from Erreka website.

General Connections and Components

General Connections Overview

Details main connections for operators, safety devices, and power supply, including indicator lights and fuses.

SW2 Functions for Programming

Explains the use of DIP switches on SW2 for enabling programming and specific functions like total/pedestrian open/close.

Radio Card Programming Procedures

Using Radio Cards

Information on using the two-channel receiver (IRRE2) and setting permanent codes with RSD receivers.

Total Opening Radio Code Programming

Step-by-step guide to programming radio codes for total opening using an RSD receiver.

Total Open;Close Programming

Procedure for programming total open/close sequences for single or dual operators, including soft stop.

Pedestrian Open;Close Programming

Method for programming pedestrian open/close sequences using specific DIP switches and ST2.

SW2 Mode and Potentiometer Adjustments

Function and Mode Selection (SW2)

Details the functions controlled by DIP switches on SW2, including opening modes, anti-crushing, and soft stop.

Potentiometer Adjustments

Guide to adjusting potentiometers for leaf delay, garage light time, standby time, and motor torque.

Erreka VIVO-M201 Specifications

General

Brand	Erreka
Model	VIVO-M201
Category	Controller
Language	English