ESP-600C Plasma Power Source Table of Contents
i
Page
Section 1 Safety
1.1 Introduction 1
1.2 Safety Notations And Symbols 1
1.3 General Safety Information 2
1.4 Installation Precautions 3
1.5 Electrical Grounding 4
1.6 Operating A Plasma Cutting Machine 4-7
1.7 Service Precautions 8
1.8 Safety References 9
Section 2 Description
2.1 General 1
2.2 General Specifications 1
2.3 Dimensions and Weight 2
Section 3 Installation
3.1 General 1
3.2 Unpacking 1
3.3 Placement 2
3.4 Input Power Connections 2-5
3.4.1 Primary Power 3
3.4.2 Input Conductors 4
3.4.3 Input Connection Procedure 4-5
3.5 Output Connections 5-6
3.5.1 Output Cables 5
3.5.2 Output Connection Procedure 5
3.6 Parallel Installation 6-7
3.7 System Interconnecting Block Diagram with Smart Flow II 8
3.8 System Interconnecting Block Diagram without Smart Flow II 9
Section 4 Operation
4.1 Introduction 1
4.2 Control Panel 1-3
4.3 Sequence of Operation 4
4.4 Arc Initiation Settings 4-7
4.4.1 Enable/Disable Arc Initiation Timer 6
4.4.2 Adjusting Arc Initiation Timer 6
4.4.3 Arc Initiation Controls 7
4.4.4 Start Current and Up-slope Timer 7
4.5 V-I Curve 8
To Next Page
Loading...
