-- 2 8 --
ba10d12e
1.3 INSTALLATION
1. Installation must be carried out by a qualified electrician.
2. Make sure the welding rectifier is set up for the available
mains supply before connecting to the mains.
3. If the control voltage is switched between 42 V and 110 V, make sure the revers -
ible rating plate shows the correct voltage.
4. For information on power cable area and fuse size, refer to technical data.
5. Connect the power cable to the rectifier in accordance with local regulations, and
make sure the correct fuse is fitted in the fuse box.
6. Check that the cooling vents on the rectifier are not obstructed.
GB
To Next Page
Loading...
