33
Using BIOS
Press <Esc> to return to the main menu setting page.
Legacy USB Support (Enabled)
Use this item to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB device at startup. If detected, the
USB controller legacy mode is enabled. If no USB device is detected, the legacy USB
support is disabled.
USB Functions (Enabled)
Use this item to enable or disable the USB function.
OnBoard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Power Management Setup
This page sets up some parameters for system power management operation.
Onboard 1394 Functions (Enabled) (optional)
Use this item to enable or disable the onboard 1394 function.
ACPI Suspend Type (S3(STR))
Use this item to define how your system suspends. In the default, S3, the suspend
mode is a suspend to RAM, i.e, the system shuts down with the exception of a refresh
current to the system memory.
PWRON After PWR-Fail (Power Off)
This item enables your computer to automatically restart or return to its operating
status.
Resume By RING (Disabled)
The system can be turned off with a software command. If you enable this item, the
system can automatically resume if there is an incoming call on the Modem. You
must use an ATX power supply in order to use this feature.
Select the ACPI
state used for
System Suspend.
Help Item
CMOS Setup Utility - Copyright (C) 1985-2007, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type S3 (STR)
PWRON After PWR-Fail Power Off
Resume by RING Disabled
Resume By PCI/PCI-E/Lan PME Disabled
Resume on RTC Alarm Disabled
Resume By PS2 KB (S3) Disabled
Resume By PS2 MS (S3) Disabled
Resume by USB (S3) Disabled
Soft-off by PWR-BTTN Instant Off
F10: Save ESC: Exit+/-/: Value
Enter : Select
F9: Optimized Defaults
F1:General Help
: Move
mnlk
To Next Page
