Escea DF700 - Running the Flue

C
28
Notes:
ͳ Should the ue not extend past the apex of the roof, the boom opening of the ue should extend at least
200mm from the roof (or 300mm in regions with heavy snow).
ͳ The installaon of a ue into a carport is not recommended.
ͳ The ue terminal will get very hot when in use. Precauons should be taken to protect people and animals
from injury.
ͳ When installing in an enclosed balcony, follow AS/NZS 5601.1 for appropriate clearances.
C9 Running the Flue
Use the following table to determine the exhaust ue clearances to combusbles:
Model 
DF700 50mm clearance for rst 0.9m
DF960 50mm clearance for rst 0.6m
Run the Ø100mm ID and Ø75mm ID (Ø110mm OD and Ø85mm OD) exible aluminium hoses from the cavity to
the rear of where the Horizontal or Vercal Power Flue Terminal will be installed. Allow enough stretch in the
exible aluminium ue to allow it to be able to protrude through the wall/ceiling/roof/ue liner to enable it to
be connected to the Power Flue Terminal. The ue should be expanded at each end in order for the ue to be
aached to the re/Power Flue. It is advisable to secure the exi ue at regular intervals to prevent vibraon,
movement and sagging. Steel wire or ‘builders strapping’ may be used for this purpose.
Note: The exible ue is shipped in a ‘compressed’ form. Extend it to your desired length by stretching.
For informaon on running the PolyPro ue , see the installaon manual which is supplied with the ue
components.
Fireplace
D
F
7
0
0
:
0
.
9
m
5
0
m
m
5
0
m
m
5
0
m
m
5
0
m
m
ø
1
0
0
m
m
E
x
h
a
u
s
t
D
F
9
6
0
0
.
6
m
D
Z
e
r
o
C
l
e
a
r
a
n
c
e
Z
e
r
o
C
l
e
a
r
a
n
c
e
: