Escea DF700 - Serial Number; Checking Operating Pressure; Cleaning the Fascia

S
53
E6.5
Room fan current too low.
Check that room fan is plugged in.
E6.6
Room fan current too high.
Check that room fan is not stalled or jammed.
Check wiring loom for damage.
E7.1
Pressure switch stuck closed
at startup
Ensure the pressure switch is mounted vercally and the diaphragm is
operaonal.
E7.2
Flue fan current too low.
Check powerue cable is correctly plugged into the re and powerue.
Check powerue cable for damage.
E7.3
Flue fan current too high.
Check powerue fan is free spinning and not stalled or jammed.
Check powerue cable for damage.
E7.4
Pressure switch does not
close during purge.
Check whether the pressure switch is acvang at startup (there is an orange
indicator LED in the control tray and near the Aux buon).
Check that both ues are securely connected at both ends to the appliance
and the Power Flue wall terminal and that the ue is not damaged.
Check that the pressure switch electrical connecon is correct.
Check that the pressure switch hoses are connected at both ends. Ensure the
hoses are not kinked.
Ensure the pressure switch is mounted vercally and the diaphragm is
operaonal. The black hose should be connected to the lighter pressure port
and the translucent hose to the darker pressure port.
Check that the fan inside the Power Flue wall terminal is running during
startup. This fan may need servicing if it is slowed or stalled.
S3 Serial Number
The serial number for the re can be found in two places. The rst is in the baery compartment of the remote
under the baeries. The second is on the data scker on the chassis under the rebox on the le hand side.
S4 
See secon E9 on page 36 of this manual.
S5 Cleaning the Fascia
The outside of an Escea Fascia must only be cleaned with a so microbre cloth. If heavier cleaning is required
for the likes of grease or stubborn ngerprint removal we recommend the use of a dedicated stainless steel
cleaner for stainless steel fascias or warm soapy water for powder coated fascias. These wipes have been tested
by Escea technicians and produce very sasfying results, when used correctly. Instrucons for their use follow.