Escea DF700 - Page 54

S
54

For Stainless Steel Fascias:
ͳ Ensure that the Gas Fireplace is o and that the fascia is cold to the touch.
ͳ Using the gloves provided with your fascia, a stainless steel cleaner and a clean cloth, apply a small
amount of cleaner to the cloth and wipe the fascia with even, straight strokes.
ͳ Make sure your strokes follow the direcon of the grain or brush nish. Wiping across the grain can leave
small scratches.
ͳ The wipe will leave a very ne lm over the fascia, ensure this lm is distributed evenly.
ͳ If the lm is applied too heavily and is quite visible, you can remove the excess by gently wiping dry with a
microbre cloth. Ensure your strokes sll follow the direcon of the grain or brush nish.
ͳ Ensure that no lm is applied to the glass of your Escea Gas Fireplace. If applied accidentally, wipe o with an
absorbent microbre cloth.
For Powder Coated Fascias:
ͳ Ensure that the Gas Fireplace is o and that the fascia is cold to the touch.
ͳ Using the gloves provided with your fascia, gently clean the fascia with a cloth and warm soapy water.
ͳ Wipe o with an absorbent microbre cloth.
Cleaning the Log Set and Glass
This is a service procedure that will need to be carried out whenever soot builds up on logs and/or inside of
glass. If soot build up becomes excessive or regular then one of the following acons may be required:
ͳ Check gas pressure; operang gas pressure may be too high.
ͳ Reposion log set so that each log is sing correctly in the log retainer bracket.
ͳ Clear any blockage from primary air port of burner.
ͳ Check ue tube is not damaged or disconnected.
For diagrams and further info on removing your fascia, reverse the steps found in secon F on page 41.
ͳ Refer to secon D2 on page 30 for instrucons on removing the glass. Note that the berglass tape around
the glass can cause marking on carpet or furnishing.
ͳ Clean the inside and outside of both pieces of glass with normal ammonia-free glass cleaning products. Use a
CLEAN DRY cloth only. Stubborn marks may be cleaned with a ceramic glass cleaner.
ͳ Replace in opposite order and test run heater.